Published


Choose a recessed LED aluminum channel when the light line should sit close to flush with the panel and there is room to route a groove. Choose a surface-mount channel when the profile should fix directly to an existing surface or the panel is too thin to recess it.
| Check | Recessed | Surface mount |
|---|---|---|
| Profile position | Body inside a groove | Body on the panel surface |
| First measurement | Cutout width, depth and remaining board thickness | Installed height and fixing clearance |
| Typical use | Flush light lines in new joinery | Lighting added under existing cabinets or shelves |
Recessed installation with GD-015
The GD-015 has a broad top flange over the channel body. Use the original cross-section to distinguish the body width, the total width across the flange and the usable strip bed. Confirm the routing dimensions from the approved drawing and test a sample in the actual board before machining the production batch.

Plan the cable exit before routing. Check that the trim covers the cut edge on both sides and that the panel retains enough thickness below the groove.
Surface mounting with SDXT-268
The SDXT-268 is a low-profile surface-mount example. Measure the space between the mounting surface and any shelf lip or door. Include the height added by the specified fixing hardware. Check cable entry and leave access to remove the diffuser for servicing.

Choose the mounting method for the application
- New kitchen cabinets. Recess the channel when the cabinet maker can route the panel and the design calls for a flush light line.
- Existing display shelves. Use a shallow surface profile where routing is impractical. Check the customer’s viewing angle and the cable route.
- Gypsum ceilings. Specify whether visible trim or a concealed plaster-in detail is required, and coordinate the opening with the installer.
Check the strip, diffuser and accessories
Compare the strip’s actual width with the usable channel bed. Allow room for the connector, solder joints and the cable exit. Test the chosen strip and diffuser together if the light line is directly visible.
LED aluminum channel size guide · LED channel diffuser guide
Request a sample or quote
Send the panel material and thickness, installation drawing, strip width, required profile lengths and quantities. Include the intended groove dimensions for recessed installations or the available fixing area for surface mounting.

